Pairing a new remote to your RC car is an easy process and should only take a few minutes of your time. It requires a few simple steps and you’ll be ready to race in no time!
The first thing you need to do is locate the receiver on your RC car. This is the small, box-shaped device that connects your remote control to the car. Once you have identified it, turn off the power switch on the receiver. This will ensure no interference when you’re attempting to pair the remote.
Next, locate the bind button on your remote control. This is usually located near the antenna on most models.
Once you have found it, hold down this button for approximately two seconds until it begins flashing.
Once the bind button is flashing, turn on the power switch of your receiver again. The receiver should now be searching for its partner remote control and should make a recognisable sound or light when it locates one.
Finally, release the bind button on your remote control. If all goes well, your RC car and its accompanying remote should now be paired correctly.
Conclusion:
Pairing a new remote to an RC car requires only a few steps and can be completed in just a few minutes’ time. Simply locate both the receiver and bind button of your RC car and its accompanying remote control, turn off power to the receiver, hold down the bind button until it begins flashing, then turn back on power to the receiver before releasing said bind button. If done correctly, these steps will ensure successful pairing between your RC car and its new remote!
