How Do You Adjust the Brakes on a Nitro RC Car?

Nitro RC cars are a great way to enjoy the thrill of racing without leaving your home. However, it’s important to make sure that your car is properly set up so that it runs smoothly and safely.

One of the most important aspects of car setup is adjusting the brakes on your Nitro RC car. Here’s how you can do it.

Step 1:

Before you begin, make sure that you have all the necessary tools for adjusting the brakes on your Nitro RC car. You’ll need a flat-head screwdriver, an Allen wrench set, and a ruler or measuring tape.

Step 2:

Start by removing the body from your Nitro RC car. This will give you access to the brake system components.

Once you’ve removed the body, you should see two brake pads attached to a metal bracket. This bracket is known as the brake caliper.

Step 3:

Using a ruler or measuring tape, measure the distance between each brake pad and its corresponding caliper. The distance should be equal on both sides. If one side is further away than the other, then this needs to be adjusted.

Step 4:

Using an Allen wrench set, loosen the two screws that hold the caliper in place. Then adjust each side of the caliper until both sides are equal distances away from their respective brake pads.

Step 5:

Tighten up both screws to ensure that everything is secure before putting your body back onto your Nitro RC car.

Conclusion:

Adjusting the brakes on a Nitro RC car is not difficult if you have all of the necessary tools and know how to use them correctly. With just a few simple steps, you can ensure that your car has properly functioning brakes for safe and enjoyable racing.

Photo of author

Stephen Dunn