Installing a hard truck bed cover is an easy way to protect and secure the cargo in your truck. It also adds a sleek and stylish look to your vehicle.
With the right tools and supplies, anyone can install a hard truck bed cover in just a few hours.
Tools and Supplies Needed
- Truck Bed Cover
- Tape Measure
- Drill
- Screws
- Screwdriver
- Leveler
- Silicone Sealant (optional)
Steps to Installing a Hard Truck Bed Cover:
(1) Measure the Truck Bed.
The first step is to measure the length and width of your truck bed. Make sure you measure from the inside edges of the bed so you get an accurate measurement for your hard truck bed cover. Record these measurements for later.
(2) Prepare the Bed.
Once you have all of your measurements, it’s time to start preparing the bed for installation. Make sure to clean off any debris or dirt that may have accumulated. Then use a leveler to ensure that all four corners are even with each other.
(3) Install Brackets.
The next step is to install brackets on each side of the bed. Line up each bracket with its respective measurement and mark where you will need to drill holes for screws.
Once you have all of your holes marked, use a drill to create pilot holes. Then insert screws into each hole and tighten them with a screwdriver.
(4) Attach Cover.
Now it’s time to attach the hard truck bed cover itself. Line up each side with its respective bracket and mark where you will need to drill additional holes for screws. Once again, use a drill to create pilot holes before inserting screws.
(5) Seal Edges (optional).
If desired, seal any gaps between the bed and cover using silicone sealant or caulk for added protection against water damage.
Conclusion:
Installing a hard truck bed cover may seem like an intimidating task at first, but with some basic tools and supplies it can be done in just a few hours by anyone who is willing to put in some effort!
