Gator Soft Roll Up Truck Bed Covers are a great way to keep your truck bed protected while still allowing easy access to the contents. The covers are made from a durable, waterproof material that will stand up to all types of weather conditions.
Installing one of these covers is relatively simple and can be done in a few hours. Here’s how:
Tools & Materials Needed:
• Tape Measure
• Phillips Screwdriver
• Utility Knife
• Gator Soft Roll Up Truck Bed Cover
Step 1: Measure Your Truck Bed
The first step is to measure the length and width of your truck bed. Make sure to measure from the top of the tailgate all the way around the edges of the truck bed. Write down these measurements so that you know what size cover you’ll need.
Step 2: Assemble The Cover
Once you have purchased a Gator Soft Roll Up Truck Bed Cover that fits your measurements, you can begin assembling it. Unroll the cover and lay it over your truck bed, aligning it so that it fits snugly against all sides.
Then use the included screws and Phillips screwdriver to attach the cover securely to your truck.
Step 3: Install The Clamps And Seals
Now that the cover is attached, you need to install clamps around the edges of your truck bed so that it stays secure even when driving at higher speeds. Use a utility knife to cut away any excess material near where the clamps will be installed. Once this is done, place each clamp in place and use a Phillips screwdriver to secure them.
Step 4: Test The Cover And Enjoy!
