Pairing a Magic Tracks RC car to its respective track is an easy and fun process. As long as you have the components needed, the entire process can take only a few minutes.
To begin, make sure your Magic Tracks RC car is charged and ready to go. Once it is fully charged, you will need to locate the red and black power cables that come with the track set.
Connect one end of the red power cable to the positive post of your Magic Tracks RC car battery and connect the other end of the cable to the positive post on the track set. Then, connect one end of the black power cable to the negative post on your Magic Tracks RC car battery and connect the other end of this cable to a ground point on your track set. Now your Magic Tracks RC car should be connected properly and you can begin pairing it with its respective track.
Programming Your Magic Tracks Remote
Next, take out your remote controller for programming. On this remote controller, there should be a button labeled “pair” or “sync.” Press this button to begin pairing your Magic Tracks RC car with its respective track. The lights on both sides of your controller should start flashing which indicates that it has begun searching for a connection with its corresponding track.
Connecting Your Car To The Track
Once you have pressed the pair button and seen that the lights are flashing on both sides of your remote controller, you can begin connecting your Magic Tracks RC car to its corresponding track. Take out any extra pieces from your Magic Tracks RC car such as antennas or headlights if they are installed and place them aside for now. Then, place one end of each power wire into a port found on either side of your car.
Now that all of these components are in place, you will need to turn on both switches located at each corner of your track set so that electricity can flow through it properly. Once these switches are turned on and all components are in place, press down firmly but gently onto each power wire until they click into their ports.
Testing Your Connection
Finally, if everything is connected correctly then all you have left to do is test out whether or not everything works properly by pressing down lightly onto either side of your controller’s joystick-like buttons which will control both acceleration and braking for your vehicle. If everything works as expected then congratulations! You have successfully paired up a Magic Tracks Remote Controlled Car with its corresponding track!
Conclusion:
Pairing up a Magic Tracks Remote Controlled Car with its corresponding track requires only a few simple steps: charging up one’s RC car battery, connecting it with power cables from its respective track set, programming one’s remote control device by pressing down onto its pair/sync button, connecting one’s vehicle to their tracks via power wires located at either side of their vehicle, turning on two switches located at each corner of their tracks set for electricity flow purposes and lastly testing out whether or not everything works properly by pressing down lightly onto either side of their controller’s joystick-like buttons.
