Pressure washing a semi-truck can be an intimidating task, but it is an important part of keeping a fleet in top condition. Pressure washing not only helps to keep a truck looking its best, but it also helps to protect the paint job and the metal components of the truck from corrosion and rust.
Pressure washing is also important for sanitation purposes. The following steps can help you properly pressure wash your semi-truck.
Step One:
Before pressure washing, make sure that you are using the right type of pressure washer. Semi-trucks typically require a higher pressure washer than what you may use to wash cars or RVs. If you do not have the right type of pressure washer, you can rent one from your local hardware store for a day.
Step Two:
Once you have the correct equipment, it is time to start cleaning! Make sure to inspect all parts of your semi-truck before starting. Be sure to remove any debris that may become lodged in the pressure washer and could cause damage. If there are any areas that require extra attention or need special cleaning solutions, make sure to address those areas before continuing.
Step Three:
Start with low pressure and gradually increase as needed.
Begin by spraying on a low setting and hold the nozzle at least 12 inches away from the surface of your truck. Work on sections at a time and then move onto another area after each section has been thoroughly cleaned. Be sure to rinse it off with clean water after each section has been cleaned.
Step Four:
Once the entire vehicle has been washed, inspect it again for any dirt or debris that may have been missed. Also check for any signs of rust or corrosion that may have occurred during the process and address them accordingly. Finally, dry off your semi-truck with a clean cloth or chamois.
Conclusion:
How Do You Pressure Wash a Semi Truck?: Pressure washing your semi-truck requires special equipment and careful consideration when doing so. Before starting, make sure that you have the right type of equipment and inspect all parts of your truck for debris or rust before proceeding with cleaning.
Start by spraying on low settings and gradually increase as needed while working on sections at a time followed by rinsing off with clean water afterwards. Finally, inspect again for any missed areas after drying off with a clean cloth or chamois.
