Where Do You Wire Truck Bed Lights?

Truck bed lights are a great way to provide extra visibility when hauling cargo or working in the bed of your truck. The light can be wired into the truck’s electrical system, allowing you to easily control it from inside the cab. Wiring truck bed lights is a relatively simple process that can be done with just a few tools and supplies.

Step 1: Gather all the materials needed for the job. You’ll need some wire, wire strippers, connectors, and a power source for the lights. If you’re wiring multiple lights, you’ll need more wire and connectors.

Step 2: Find a good place to mount the lights. The best place is usually at the back of your truck bed, near the tailgate. Make sure that this area is not blocked by any items in your truck bed or by any fuel tanks.

Step 3: Determine how you want to run your wiring. If you’re only running one light, then it’s best to run one wire from your power source to each light. If you’re running multiple lights, then it’s best to run two wires from each light – one for power and one for ground.

Step 4: Connect the wires to the lights using connectors. Make sure that they are securely connected and that they are insulated properly so that no bare wires are exposed.

Step 5: Connect the other end of each wire to its corresponding power source or ground point. You may need to use additional connectors if you have multiple lights wired together.

Step 6:

With these steps complete, you should now have your truck bed lights wired up and ready for use! Just remember to always keep safety in mind when working with electricity – never leave any exposed wires or connections unattended.

With proper care and attention, wiring up truck bed lights can be an easy job with great results!

Where Do You Wire Truck Bed Lights? Wiring truck bed lights is an easy job that can be done with just a few tools and supplies. Start by gathering materials such as wire, connectors, and a power source for the lights.

Mount them in an appropriate location near the back of the truck bed before running wiring between them and their corresponding power sources or ground points. Finally, test out your wiring before enjoying extra visibility while hauling cargo or working in the bed of your truck!


Photo of author

Susan Delgado